Grid forming wind power plantsblack start operation for hvac grids and diode rectifier-based wind power plant integration

Zusammenfassung

The European Union GREEN DEAL aims to make its 27 members climate-neutral by 2050. The decarbonization of the energy sector stands out as one of the proposed actions. To achieve that goal, the target for wind power generation is set at 1,200 GW in 2050, from the 190 GW that was had in 2019. The closure of power plants based on large synchronous generators and the increase of power electronics based generation such as Wind Power Plants (WPPs) or photovoltaic plants, leads to the use of grid forming controllers for power electronics based renewable energy. Grid forming control strategies for wind turbines generators (WTGs) must consider active and reactive power sharing control (droop control in synchronous generators) as well as a protection system that allows a quick recovery after fault clearance. Moreover, a transition from the conventional grid following WPPs to new grid forming WPPs is required. The transition must consider the parallel operation of both technologies for a long time. Thus, it is necessary to study the stability of Wind Power Plants with both technologies, as well as the study of how much grid forming generation is required to keep a mixed grid forming and grid following WPP stable in any situation. In addition, the use of grid forming WPPs allows different applications such as the energization of HVAC and HVDC grids after a blackout from these WPPs, or the use of diode rectifiers in HVDC links for the off-shore WPPs connection. An aggregation technique for type-4 WTGs has been proposed in this thesis in order to facilitate the study and design of grid forming WPPs. The aggregation technique allows to reduce the WPP complexity for its study and analysis. The main contributions of this theses are: A design methodology has been proposed for the parallel operation of grid forming and grid following WTGs. Including the stability analysis of the complete system. Additionally, a fault control strategy is proposed to ensure a fast and safe recovery. The use of H¿ control techniques is also proposed for grid forming controller tuning. Using H¿ control techniques for controller design may improve the robustness of the controllers as well as the performance of the controllers. A procedure to carry out black start operation of HVAC grid from mixed grid forming and grid following WPPs has been proposed. The obtained results validate that the procedure works as expected. Moreover, the results show that the amount of grid-forming generation usually is determined by the load size steps as stability limits are usually less stringent. Finally, protection strategies have been proposed for the integration of off-shore WWPs in multi-terminal HVDC grids using diode rectifiers. Grid forming WPPs are able to help managing faults. Their use allow lower requirements of the HVDC protection equipment, leading to overall cost reduction and an increment of the system robustness.